![]() ![]() When set to Stereo, limiting will be applied to both channels whenever either of the channels requires compression. Stereo-L/R: This switch toggles between stereo limiting or L/R limiting.Conversely, input signals above this level will be limited. If the incoming signal is below this level, the signal will not be limited. Ceiling: This control will set the maximum output level of the limiter.This knob is disabled when Auto Release is enabled. Release: This knob sets the amount of time it takes for the effect to stop limiting after the signal has crossed below the ceiling.If this switch is disabled, the Release time knob can be used manually. Auto Release: When this switch is enabled, the limiter will automatically adjust its release time based on behavior of the input signal.The shorter the time is, the greater the compression will be since all the peaks will be “caught” by the limiter, yielding more distortion. Lookahead Time: This drop-down window lets the user select the time it takes for the limiter to respond to peaks. ![]() Gain: This knob controls the level of the incoming signal before applying the limiting.Limiter has 6 different parameters we can control, these are: The picture above shows the graphic interface of Limiter. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |